Differences

This shows you the differences between two versions of the page.

--- moldmaking:2._pour_the_silicone [2016/03/28 17:48] – created yeeunkim
+++ moldmaking:2._pour_the_silicone [2016/05/02 18:35] (current) – yeeunkim
@@ Line 1: / Line 1: @@
-) Figure out how much silicone you need by calculating the volume of the box.
+) Figure out how much silicone you need by calculating the volume of the box.(the volunme of the box: the amount of silicone = 1:1)
 ) Measure the silicone and mix it. Don’t make any mistake of not mixing thoroughly. There’s nothing worse than wasting a mold because of inadequate mixing.
-{{:moldmaking:20160324_145823_hdr.jpg?200 |}}
+{{:moldmaking:20160324_145823_hdr.jpg?200|}}
-) After mixing the silicone, remove the bubbles with orbital palm sander while mixing it
+) After mixing the silicone, remove the bubbles with orbital palm sander while mixing it.
-{{:moldmaking:20160324_151411_hdr.jpg?200 |}}
+{{:moldmaking:20160324_151411_hdr.jpg?200|}}
 ) Pour the silicone in one location into the box. Pour as thin a stream as you can.
-{{:moldmaking:20160324_155500_hdr.jpg?200 |}}
+{{:moldmaking:20160324_155500_hdr.jpg?200|}}
 ) Again, remove the trapped bubbles in the mold by agitating it with an orbital palm sander about 5 minutes.
-{{:moldmaking:20160324_155518_hdr.jpg?200 |}}
+{{:moldmaking:20160324_155518_hdr.jpg?200|}}