DASL Wiki

User Tools

Site Tools

Trace:
making_the_y_axis_motor_seats

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
making_the_y_axis_motor_seats [2016/04/11 01:28] – suyongleemaking_the_y_axis_motor_seats [2016/04/13 21:15] (current) – suyonglee
Line 9: Line 9:
  
 2. Attach the square on the stand of the Y-axis. 2. Attach the square on the stand of the Y-axis.
 +
 +{{:20160408_214214.jpg?200|}}
 +{{:20160408_214228.jpg?200|}} -3
  
 3. Attach the stepper motor to each of the seats. 3. Attach the stepper motor to each of the seats.
  
-4. Connect the control board and Power supply (upload soon)+{{:20160412_134719.jpg?200|}} 
 +{{:20160412_185421.jpg?200|}} -4 
 + 
 +4. Connect the control board and Power supply. if stepper motor's wire length is short, you can extend the wire with soldering. In my case, I extend the Y-axis stepper motor's wire 50inch and the X-axis's 20 inch. 
 + 
 +{{:20160408_214204.jpg?200|}}
making_the_y_axis_motor_seats.1460363304.txt.gz · Last modified: by suyonglee