Differences

This shows you the differences between two versions of the page.

--- making_the_y_axis_motor_seats [2016/04/03 19:01] – created suyonglee
+++ making_the_y_axis_motor_seats [2016/04/13 21:15] (current) – suyonglee
@@ Line 2: / Line 2: @@
 **Making the Y axis motor seats**
-(Upload soon)
+. before making the Y axis motor seats, I found the Y-axis moving square is too high to move a lot. so I take to pieces the machine, and attach the Y-axis moving square to bottom.
+. Cut the 6x3 inch square, and make a whole to the same whole of the X axis motor seats.
+. Attach the square on the stand of the Y-axis.
+{{:20160408_214214.jpg?200|}}
+{{:20160408_214228.jpg?200|}} -3
+. Attach the stepper motor to each of the seats.
+{{:20160412_134719.jpg?200|}}
+{{:20160412_185421.jpg?200|}} -4
+. Connect the control board and Power supply. if stepper motor's wire length is short, you can extend the wire with soldering. In my case, I extend the Y-axis stepper motor's wire 50inch and the X-axis's 20 inch.
+{{:20160408_214204.jpg?200|}}