DASL Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
**Making the X axis moving part**

{{:hotwire03.jpg?200|}}
-Drawing part

1. Prepare 24” (600nm) Drawer Slide x4

2. Cut the quadrangle for 32x8inch size x2, 8x6inch size x2, 19x6inch sixe x2(reuse the wrong size Y-axis board), and 3x3inch x4

{{:20160401_181155.jpg?200|}} 
-3.,4.

3. Make a whole in 19x6inch board, this whole sixe is same and parallel to the X axis motor seats. so when you make a whole, 1.4 inch diameter, you have to be consider the bottom stuff's height such as 32x8 inch and 8x6inch board, and drawer slide. In my case the bottom stuff's height is 1 inch, so I make a center of the whole in 1.3inch height, and 3 inch by widthwise.

4. stand the Y axis moving part and the board that has a whole on the 8x6inch size board using screws

{{:20160401_181423.jpg?200|}}
-5
{{:20160401_193335.jpg?200|}}
-5-1

5. if you finish the standing, you have to fix the bottom side of 8x6inch board to the Drawer slide using screws but, If you use just 2 screws to fix it, it will not be fixed.

5-1 so, you should use 4 screws to fix it.

6. if you finish the fixing, make it attach the 32x8inch board, when you attach it, left the 3inch space for X axis motor seats.

{{:20160401_205445.jpg?200|}}
-7

7. attach the 3x3 size board to the left 3inch space, and attach the X axis motor seats.