tormach_settings
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| tormach_settings [2025/08/15 18:37] – [Endmill Specific Settings] enowery | tormach_settings [2025/08/15 18:38] (current) – [Endmill Specific Settings] enowery | ||
|---|---|---|---|
| Line 22: | Line 22: | ||
| - Flutes: 4 | - Flutes: 4 | ||
| \\ | \\ | ||
| - | - Feed per Tooth: 0.0015in | + | - Feed per Tooth: 0.0015 in. |
| \\ | \\ | ||
| - Cutting Feedrate: max 30in/min (this was decreased down to ~20in./min for the finishing feedrate) | - Cutting Feedrate: max 30in/min (this was decreased down to ~20in./min for the finishing feedrate) | ||
| Line 30: | Line 30: | ||
| - Maximum Stepover: 0.125in (1/2 the diameter) | - Maximum Stepover: 0.125in (1/2 the diameter) | ||
| \\ | \\ | ||
| - | ** 1.5 in. Face Endmill** | + | ** 1.5 in. Face Mill** |
| + | \\ | ||
| + | Note: Face Mills must be run at a slower RPM. | ||
| \\ | \\ | ||
| - RPM: 3000 | - RPM: 3000 | ||
tormach_settings.txt · Last modified: by enowery