Differences

This shows you the differences between two versions of the page.

--- suhani_week_6 [2024/09/02 15:20] – suhanik
+++ suhani_week_6 [2024/09/02 15:27] (current) – suhanik
@@ Line 13: / Line 13: @@
 ===== End Effector: =====
-One sensor cannot give out the values of the current pulled by two motors separately. Thus, there was a need for integrating two sensors to the end effector. But integrating and getting them to work wasn’t an easy task at all! Following is the circuit diagram which I made after understanding the ports and electric current flow. Patience and persistence always pay off! It worked. I am now able to collect the values of currents properly. Using motor theory, I converted it to torque and then, by using tables, I calculated tension. But whatever the values of tensions I am getting are too much large. There is a need to go through the calculations and take a look at what exactly is happening.
+{{ ::screenshot_2024-09-02_at_3.21.34 pm.png?nolink&400 |}}
+One sensor cannot give out the values of the current pulled by two motors separately. Thus, there was a need for integrating two sensors to the end effector. But integrating and getting them to work wasn’t an easy task at all! Following is the circuit diagram which I made after understanding the ports and electric current flow. Patience and persistence always pay off! It worked.
+{{ ::cdpr_3.jpeg?nolink&600 |}}
+I am now able to collect the values of currents properly. Using motor theory, I converted it to torque and then, by using tables, I calculated tension. But whatever the values of tensions I am getting are too much large. There is a need to go through the calculations and take a look at what exactly is happening.
+{{ ::screenshot_2024-09-02_at_3.23.21 pm.png?nolink&600 |}}
 I made one animation for 2D planar CDPR demonstrating the relation between the position of cable lengths. Now I have started working on a heat map for the simulation of the workspace.
+{{ ::screenshot_2024-08-31_at_8.04.36 pm.png?nolink&400 |}}
 ===== Projectile Launcher: =====
+{{ ::screenshot_2024-09-02_at_3.24.59 pm.png?nolink&600 |}}
 I made a pretty big (comparatively big) projectile launcher for projecting anchors. I also got 3D printed two anchors which will hold the string and get stuck so that anchor points can be fixed on the wall.
+{{ ::screenshot_2024-09-02_at_3.25.06 pm.png?nolink&400 |}}
 I am aiming to complete the demo of the project by this Friday.
-SWITCH: Hugeness was mind-boggling.
+----
+===== SWITCH: Hugeness was mind-boggling. =====
+{{ ::screenshot_2024-09-02_at_3.27.03 pm.png?nolink&600 |}}
 In the middle of the week, we all visited SWITCH, which is one of the huge data centers in the world.