Differences

This shows you the differences between two versions of the page.

--- software_setup_dw [2016/11/05 17:48] – [Running HUBO in Reality] dwallace
+++ software_setup_dw [2017/04/27 21:53] (current) – dwallace
@@ Line 35: / Line 35: @@
   d. Open the ALPrograms.pro file in the podo_nrl/src directory of the HUBO files
 **4.** Rebuild all\\
-**5.** Confirm the build directory is correct for your system\\
+**5.** Confirm the build directory is correct for your system (use the Project tab)\\
 **6.** Run PODOLauncher\\
@@ Line 58: / Line 58: @@
 **1.** Run PODO Launcher on the motion PC\\
-**2.** Start GUI
+**2.** Start GUI\\
-**3.** Start Daemon
+**3.** Start Daemon\\
 **4.** Open the ALs you require (walk-ready recommended)\\
 **5.** Use the AL accordingly to give commands to HUBO\\
@@ Line 79: / Line 79: @@
 **4.** Open the ALs you require\\
 **5.** Use the AL accordingly to give commands to the HUBO in simulation\\
+**6.** Use Gazebo to visualize HUBO interacting with the simulation\\
+**7.** Use Rviz to visualize sensor data from the simulation\\
+==== Final Words ====
+This tutorial's objective was to teach the concepts behind the software overview for DRC-HUBO. Complete operation instructions for setting up the development and simulation environment for DRC-HUBO were provided. Once the concepts were conveyed the reader could successfully build the PODO system and setup DRC-HUBO in simulation.
+\\
+\\
+For questions, clarifications, etc, Email: <wallad3@unlv.nevada.edu>