Differences

This shows you the differences between two versions of the page.

--- robotino_nav_tutorial [2018/11/29 19:39] – jkreitz
+++ robotino_nav_tutorial [2018/12/05 15:08] (current) – jkreitz
@@ Line 1: / Line 1: @@
+**Robotino Demo Tutorial**
 **Background**
@@ Line 14: / Line 16: @@
 Once you are able to access Robotino’s main menu, select the following menu sequence
-  * Unordered List Item“Network”
+  * “Network”
-  * Unordered List Item“Eth0”
+  * “Eth0”
-  * Unordered List Item“DHCP”
+  * “DHCP”
-  * Unordered List Item“Activate”
+  * “Activate”
 Once the menu says “success,” press the left arrow key until you get back to “Network.” Double check the IP address - you will need it for the ROS node.
@@ Line 45: / Line 47: @@
 d is the maximum range from the obstacle you would like Robotino to move.
-After updating any of the values, make sure you cakin_make in the catkin_ws directory.
+After updating any of the values, make sure you catkin_make in the catkin_ws directory.
+Note: Potential Field only works well with one obstacle.
 ---------------------------------------
-To use Robotino Potential Field demonstration, follow these steps
+To use Robotino Potential Field demonstration, open a terminal and input the following:
-Open Terminal
-"$ roslaunch robotino_node robotino_node.launch hostname:=<Robotino IP Address>"
-Then open a new terminal and navigate to the Catkin Workspace. Input the following commands in the shell:
+  * "roslaunch robotino_node robotino_node.launch hostname:=<Robotino IP Address>"
-"cd catkin_ws/"
-"catkin_make"
+Then open a new terminal and input the following commands in the shell:
-"rosrun vikram yahoo"
+  * "cd catkin_ws/"
+  * "catkin_make"
+  * "rosrun vikram yahoo"
 The Robotino demonstration will run once you input the rosrun command.
+==== Potential field ====
+\\
+{{ youtube>X1TTRiAJsB4?large }}
+{{ youtube>zp9GgoVG31A?large }}
+\\
 ---------------------------------------
@@ Line 78: / Line 93: @@
 After updating any of the values, make sure you cakin_make in the catkin_ws directory.
+Note: Breadth First works well with less than four obstacles.
+---------------------------------------
+To use Robotino Breadth First demonstration, open a terminal and input the following:
+  * "roslaunch robotino_node robotino_node.launch hostname:=<Robotino IP Address>"
+Then open a new terminal and input the following commands in the shell:
+  * "cd catkin_ws/"
+  * "catkin_make"
+  * "rosrun vikram bfs" (if bfs doesn't work, use "move")
+The Robotino demonstration will run once you input the rosrun command.
+==== Breadth First ====
+\\
+{{ youtube>sUl7V03U05A?large }}
+\\