Differences

This shows you the differences between two versions of the page.

--- p-series_36x24_co2_laser [2016/06/07 13:03] – suyonglee
+++ p-series_36x24_co2_laser [2016/06/07 19:01] (current) – suyonglee
@@ Line 28: / Line 28: @@
 •1. ProLF Laser engraving Machine.
-\\ {{::20160606_182603.jpg?300|}} \\
 •2. Exhaust fan & Tubing.
+ The exhaust blower removes smoke and fumes from the case and exhaust them to the out side of the building
 \\ {{::20160606_182517.jpg?300|}} \\
 •3. Air compressor.
+ Air is used as a pressurized gas to assist in cutting and engraving operations. The Pressurized air is critical to safe and efficient cutting operations as it not only helps cut through material, but also helps prevent the formations of flames
 \\ {{::20160606_182542.jpg?300|}} \\
 •4. Water Chiller.
+ Water chiller replaces the water pump.
+ Water Pump helps the tube cool.
+ the water tube helps a flow of room-temperature water to regulate the temperature of resonance chamber *but, keep no air bubbles inside of the water jacket of the laser tube, air bubbles can create local hot spots in the resonance chamber and reduce the lifetime of tube
+\\ {{::20160606_182603.jpg?300|}} \\
 \\ {{::20160606_182549.jpg?300|}} \\
@@ Line 45: / Line 55: @@
 •5. Honeycomb cutting table and Knife-edge table.
-\\ {{::20160606_182533.jpg?300|}} \\
+\\ {{::20160607_170810.jpg?300|}} \\
 •6. Focus ruler.
+\\ {{::20160606_182533.jpg?300|}} \\
 **Software :**
  Retina Energy
+\\ {{::retinaengrave3d_manual.pdf?300|}} \\