Differences

This shows you the differences between two versions of the page.

--- making_the_x_axis_motor_seats [2016/04/01 16:19] – created suyonglee
+++ making_the_x_axis_motor_seats [2016/04/01 16:45] (current) – suyonglee
@@ Line 1: / Line 1: @@
- **Making the X axis motor seats**
+**Making the X axis motor seats**
+{{:hotwire01.jpg?200|}}
+-Drawing part
+{{:20160328_202302.jpg?200|}}
+-front side picture
+{{:20160328_202309.jpg?200|}}
+-back side picture
+. Cut the quadrangle for 6x6inch size x2 and 6x3inch x2
+. Make a whole, 1.4 inch diameter, in the 6x6inch wood to suit for stepper motor!
+- the center of the whole's position: center of the width (3 inch by widthwise), 2.3inch of the height
+- It must be considered with motor's center
+. assemble the 6x6inch wood and 4x4inch wood to be perpendicular!
+- When I screw the 2 structure, It was hard to make it stand perpendicularly, so I screwed the small size square on the both side the structure.