Differences

This shows you the differences between two versions of the page.

--- ip_const_pneumatic [2016/03/13 00:29] – created joaomatos
+++ ip_const_pneumatic [2016/03/16 12:40] (current) – joaomatos
@@ Line 1: / Line 1: @@
+**CONNECTING THE PROPORTIONAL VALVE TO THE AIR COMPRESSOR **
+ You will need one of this air compressor tool , that you can open and close the air flow between the air compressor and the proportional valve. Connect this tool to the proportional valve , on the input port of the middle (opposite side of the output ports ) as shown in the pictures bellow
+{{::comp_pip.jpg?direct|}}
+{{::comp.jpg?direct|}}
 **TESTING THE PROPORTIONAL VALVE**
+ Be sure that your code works testing the relation between the proportional valve and your encoders. If you did everything right at the Coding section , when you upload the code into the Arduino and let it run , the system will be steady , and it will move if you move the encoders. To be sure that its working , take the rotational encoder and rotate it and see if the movement of the cart is in the right direction in order to balance the pendulum. In my case , when i rotate the encoder clockwise , the cart should drive backward , to balance it.
 {{youtube>3e65Pi_bIb4?medium}}