clear_soap_with_a_toy_inside
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| clear_soap_with_a_toy_inside [2025/03/27 22:56] – yehyun | clear_soap_with_a_toy_inside [2025/03/27 23:07] (current) – yehyun | ||
|---|---|---|---|
| Line 126: | Line 126: | ||
| To enhance the uneven texture of the surface, gently shape it with a stick while it’s still semi-soft. | To enhance the uneven texture of the surface, gently shape it with a stick while it’s still semi-soft. | ||
| - | \\ (2) Planet Base | + | \\ (2) Robot & Earth Layer |
| + | {{ : | ||
| 2-1. Pour the clear base | 2-1. Pour the clear base | ||
| Pour the clear soap base (see Section01) into the mold, filling approximately 1/4 of its height. | Pour the clear soap base (see Section01) into the mold, filling approximately 1/4 of its height. | ||
| Line 138: | Line 139: | ||
| Spray alcohol on the surface to remove any bubbles. | Spray alcohol on the surface to remove any bubbles. | ||
| Wait until the layer is fully set. | Wait until the layer is fully set. | ||
| + | | ||
| + | 2-4. Pour another layer of clear base | ||
| + | Pour another thin layer of clear base over the charm to give a sense of distance between the robot and the Earth. | ||
| + | Repeat the same procedure as in steps 2-1 to 2-3(excluding the charm placement in 2-2). | ||
| + | | ||
| + | 2-5. Create Earth’s land | ||
| + | Mix green color powder with the clear base. | ||
| + | Using a stick, gently apply the mixture to a corner of the top layer inside the mold to represent Earth’s land. | ||
| + | | ||
| + | 2-6. Create Earth’s ocean | ||
| + | Mix blue color powder with the clear base. | ||
| + | Tilt the mold slightly so that the mixture pours into the opposite corner of the land section. | ||
| + | Pour slowly so the blue layer slightly overlaps the green land area, representing the sea surrounding the continent. | ||
| + | Hold the tilted position until the soap begins to set and stays in place. Then gently place the mold back down. | ||
| + | | ||
| + | 2-7. Pour the background layer | ||
| + | Prepare the final background layer by tinting the clear base with dark colors such as black or deep blue and adding a touch of silver for a cosmic effect. | ||
| + | If bubbles form during mixing, let the base cool slightly until a thin film appears, then remove the film to avoid trapping bubbles in the final soap. | ||
| + | | ||
| + | 2-8. Final pour | ||
| + | Slowly pour the colored base into the mold over the fully set layers. | ||
| + | Pouring too quickly can disturb the layers beneath. | ||
| + | Spray alcohol to eliminate surface bubbles. | ||
| + | | ||
| + | 2-9. Completion | ||
| + | Allow the soap to fully harden and cool. | ||
| + | Carefully remove it from the mold. | ||
| + | To preserve the clarity of the transparent layers, wrap the finished soap in plastic wrap immediately. | ||
| + | |||
| + | |||
clear_soap_with_a_toy_inside.1743141370.txt.gz · Last modified: by yehyun