tutorialtemplate
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tutorialtemplate [2016/06/05 18:10] – pauloh | tutorialtemplate [2023/06/18 19:39] (current) – ischneweis | ||
---|---|---|---|
Line 49: | Line 49: | ||
^PART NAME/ | ^PART NAME/ | ||
| Smooth-on Silicone Mold Rubber | | Smooth-on Silicone Mold Rubber | ||
- | | <???> | + | | <???> |
- | | <???> | + | | <???> |
- | | <???> | + | | <???> |
- | | <???> | + | | <???> |
\\ | \\ | ||
Line 62: | Line 62: | ||
\\ | \\ | ||
- | ==== Construction | + | ==== Setup ==== |
- | This section gives step-by-step instructions along with photos to <fill in the blank>. (If a circuit-building tutorial:) A schematic to construct <fill in the blank> is shown here <add image>. <Add hyperlink to PDF of schematic> | + | This section gives step-by-step instructions along with photos to Setup Avatar DARWIN. |
\\ | \\ | ||
\\ | \\ | ||
**Step 1** | **Step 1** | ||
+ | \\ Plug in a USB extension port to the side of DARWIN (circled in red) | ||
+ | \\ (*Make sure to use the 90° degree connector so DARWIN doesn’t accidentally knock it out!) | ||
\\ | \\ | ||
- | \\ | + | {{}} |
- | <Add photos to make step easier to understand> | + | |
\\ | \\ | ||
\\ | \\ | ||
Line 105: | Line 106: | ||
\\ | \\ | ||
\\ | \\ | ||
- | For questions, clarifications, | + | For questions, clarifications, |
tutorialtemplate.1465175447.txt.gz · Last modified: 2016/06/05 18:10 by pauloh