polaris_2014_ranger_900_xp_all-terrain-vehicle_atv
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | polaris_2014_ranger_900_xp_all-terrain-vehicle_atv [2022/07/14 17:33] (current) – created adave | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | <fs x-large> | ||
+ | \\ | ||
+ | **Author:** Giuk Yeom\\ | ||
+ | **Email:** [email protected]\\ | ||
+ | **Date:** Last Edited 06/ | ||
+ | **Keywords: | ||
+ | \\ | ||
+ | Model: Polaris 2014 Ranger 900 XP\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | if you need more details about Polaris, click [[https:// | ||
+ | \\ | ||
+ | \\ | ||
+ | <fs medium> | ||
+ | polaris has 2 kill switches. One is easy to find out, but another kill switch is in the box that exist top of the car.\\ | ||
+ | Please read and follow the maintenance manual before reading this document. Some details are specified in maintenance guidelines. it exists in Polaris.\\ | ||
+ | Do not leave kill switches on when the engine is not running for a long time. It may cause a discharge.\\ | ||
+ | \\ | ||
+ | <fs medium> | ||
+ | 1. No fuel\\ | ||
+ | 2. Battery replacement required\\ | ||
+ | 3. No coolant\\ | ||
+ | 4. No air in tire\\ | ||
+ | A maintenance plan was created based on this information\\ | ||
+ | \\ | ||
+ | <fs medium> | ||
+ | 1. List up purchasing\\ | ||
+ | 2. Battery replacement\\ | ||
+ | 3. Adding fuel and coolant\\ | ||
+ | 4. Checking functions\\ | ||
+ | 5. Test drive\\ | ||
+ | The maintenance plan is not fixed, and new step may be added when new problems arise during maintenance.\\ | ||
+ | \\ | ||
+ | **step 1. List up**\\ | ||
+ | Battery 575CCA\\ | ||
+ | Coolant 50/50\\ | ||
+ | Engine Oil\\ | ||
+ | {{: | ||
+ | \\ | ||
+ | (It is correct to change the engine oil according to the period. However, it was not replaced because the color was the same as the new engine oil.)\\ | ||
+ | |||
+ | **step 2. Battery replacement**\\ | ||
+ | {{: | ||
+ | \\ | ||
+ | For replacing the battery, make sure that the positive pole should be connected to the battery before the negative pole.\\ | ||
+ | After replacing battery, you could find out Polaris start to crank.\\ | ||
+ | |||
+ | **step 3. Add fuel and coolant**\\ | ||
+ | After adding fuel and coolant, you are ready to drive the Polaris.\\ | ||
+ | If Polaris could not start the engine although you could hear good crank, this is caused because of fuel pump.\\ | ||
+ | Note that even if the symptom is shown, it is not always a problem with the fuel pump.\\ | ||
+ | \\ | ||
+ | **step 3-1. Fuel pump replacement**\\ | ||
+ | {{: | ||
+ | Before replace a fuel pump, you need to remove all seat.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | For clean fuel, wipe the area around the pump with a wet tissue.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | After cleaning dust and sand, remove bolt to replace fuel pump easily.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | Remove clips connected to the fuel pump.\\ | ||
+ | Use channellock to replace a fuel pump.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | After replacing the fuel pump, install it in the reverse order of removal.\\ | ||
+ | If you need more details about fuel pump replacement, | ||
+ | \\ | ||
+ | **step 4. Checking functions** | ||
+ | {{ : | ||
+ | After replacing fuel pump, engine successfully started.\\ | ||
+ | Also, it was confirmed that the brake and accelerator was operating normally.\\ | ||
+ | \\ | ||
+ | **step 5. Test drive**\\ | ||
+ | {{ : | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
polaris_2014_ranger_900_xp_all-terrain-vehicle_atv.txt · Last modified: 2022/07/14 17:33 by adave