making_the_y_axis_moving_part
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
making_the_y_axis_moving_part [2016/04/01 16:56] – suyonglee | making_the_y_axis_moving_part [2016/04/01 17:00] (current) – suyonglee | ||
---|---|---|---|
Line 6: | Line 6: | ||
{{: | {{: | ||
-1st trial, but it is wrong size | -1st trial, but it is wrong size | ||
- | |||
- | 1. Prepare the Cut the quadrangle for 19x6inch size x2 | ||
{{: | {{: | ||
-2nd trial | -2nd trial | ||
+ | 1. Prepare 18” (450nm) Drawer Slide x4 | ||
+ | 2. Cut the quadrangle for 19x6inch size x2 but, It is too small space to move Y axis, so changed the size. | ||
- | 2. Make a whole, | + | 2-1. Cut the quadrangle |
- | - the center of the whole' | + | |
- | - It must be considered with motor' | + | |
- | + | ||
- | 3. assemble the 6x6inch wood and 4x4inch wood to be perpendicular! | + | |
- | - When I screw the 2 structure, It was hard to make it stand perpendicularly, | + | |
+ | 3. Screw the Drawer Slide to 22x6inch structure from bottom side. |
making_the_y_axis_moving_part.txt · Last modified: 2016/04/01 17:00 by suyonglee