make_the_stablizers
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
— | make_the_stablizers [2016/03/20 19:24] (current) – created dongbinkim | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | **-Make the stablizers** | ||
+ | |||
+ | {{: | ||
+ | |||
+ | 1. Cut out the 2 stabilizers following the template out of the foamed plastic insulation. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | 2. Use scotch packaging tape to cover the edge to be secure. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | 3. Line up the stabilizers right next to the rods about 3/4" forward of the hinge. Carefully cut the frame for the stabilizer legs. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | 4. Attach the stabilizers on the frame. | ||
make_the_stablizers.txt · Last modified: 2016/03/20 19:24 by dongbinkim