labview_nxt_tutorial
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
labview_nxt_tutorial [2017/08/02 10:48] – yuhanghe | labview_nxt_tutorial [2017/08/02 10:54] – [Section 1.5: Running NXT motor] yuhanghe | ||
---|---|---|---|
Line 125: | Line 125: | ||
==== Section 1.5: Running NXT motor ==== | ==== Section 1.5: Running NXT motor ==== | ||
- | In this section, you will learn how to use LabVIEW to program a NXT motor to run for 5 seconds then brake. Create a new VI through Robot Project Center. On the block diagram, right click to open function palettes -> '' | + | In this section, you will learn how to use LabVIEW to program a NXT motor to run for 5 seconds then brake. Create a new VI through Robot Project Center. On the block diagram, right click to open function palettes -> '' |
\\ \\ | \\ \\ | ||
{{ : | {{ : |
labview_nxt_tutorial.txt · Last modified: 2017/08/15 15:47 by yuhanghe