Differences

This shows you the differences between two versions of the page.

--- how_to_make_a_chair_cover_with_name [2019/01/07 17:52] – myeonggeonkim
+++ how_to_make_a_chair_cover_with_name [2019/01/11 14:12] – myeonggeonkim
@@ Line 104: / Line 104: @@
 . Cut the fabric that you are going to use for the chair cover. The fabric size should be bigger than the planer figure.
 \\
-Put the fabric on the laser cutter
+-Put the fabric on the laser cutter
 \\
-Check the [[http://www.daslhub.org/unlv/wiki/doku.php?id=full_spectrum_laser_pro_36x24_intro_and_quick_start&s[]=laser&s[]=cutter | laser cutting tutorial]] especially ‘Machine Prep and Check’ section.
+- *Check the [[http://www.daslhub.org/unlv/wiki/doku.php?id=full_spectrum_laser_pro_36x24_intro_and_quick_start&s[]=laser&s[]=cutter | laser cutting tutorial]] especially ‘Machine Prep and Check’ section.
 \\
-Make sure that laser cutter is on and connected with Retina engrave.
+- Make sure that laser cutter is on and connected with Retina engrave.
 \\
-Check your work place on laser cutter by pressing ‘J or P’ on Retina engrave.
+- Check your work place on laser cutter by pressing ‘J or P’ on Retina engrave.
 \\
-After checking the work place, adjust location of fabric and put magnets on the safe location on the fabric. This step will help the fabric not to be moved by air compressor.
+- After checking the work place, adjust location of fabric and put magnets on the safe location on the fabric. This step will help the fabric not to be moved by air compressor.
 \\
 {{:mgkim:set1.jpg?200|}}