User Tools

Site Tools


hitechnic_angle_encoder

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
hitechnic_angle_encoder [2017/08/21 15:09] – [Motivation and Audience] yuhanghehitechnic_angle_encoder [2017/08/28 16:28] – [Final Words] yuhanghe
Line 51: Line 51:
   *''Total Angle'': returns the accumulated number of degrees an axle has rotated   *''Total Angle'': returns the accumulated number of degrees an axle has rotated
   *''RPM'': returns the speed of the axle rotation in RPM (revolutions per minute)   *''RPM'': returns the speed of the axle rotation in RPM (revolutions per minute)
-  *''All info+  *''All Info'': returns all three readings in a cluster structure
  
 +To reset the angle and accumulated angle, use the HT config node, which can be assessed under ''Hitechnic Sensors''.
 +\\ 
 +''HT Wait For'', which is also under ''Hitechnic Sensors'' group, can also be used to interact with Angle Sensor.
 +  *''Within 1 Degree'': wait until Angle Sensor angle reading is within 1 degree of the targeted value
 +  *''Within 5 Degree'': wait until Angle Sensor angle reading is within 5 degree of the targeted value
 +  *''Change'': wait until Angle Sensor accumulated angle is more than the targeted value
 +
 +{{ :yuhang:hitechnic_angle_encoder:wait_for.png | HT Wait For}}
 ===== Example ===== ===== Example =====
 +
 +Here is a simple example that displays the three sensor readings from Angle Sensor.
 +
 +{{ :yuhang:hitechnic_angle_encoder:example_block_diagram.png | Block Diagram}}
 +{{ :yuhang:hitechnic_angle_encoder:front_panel_set_up.png?500 | Front Panel}}
 +
  
 ===== Measure Pendulum Angle ===== ===== Measure Pendulum Angle =====
Line 59: Line 73:
 ===== Final Words ===== ===== Final Words =====
  
-This tutorial's objective was to <fill in the blank>. Complete <choose: construction details, source code and program descriptions> for <fill in the blank>. Once the concepts were conveyed the reader could <fill in the blank>+This tutorial's objective was to demonstrate how to use LabVIEW to program HiTechnic Angle Sensor. Once the concepts were conveyed the reader could use LabVIEW module for Lego MINDSTORM to program NXT and HiTechnic Angle Sensor.
-\\ +
-\\ +
-Speculating future work derived from this tutorial, includes <fill in the blank>. In the big picture, the problem of <fill in the blank> can be solved with this tutorial.+
 \\ \\
 \\ \\
-For questions, clarifications, etc, Email: <paul.oh@unlv.edu> +For questions, clarifications, etc, Email: <hey6@unlv.nevada.edu> 
  
  
hitechnic_angle_encoder.txt · Last modified: 2017/08/28 17:25 by yuhanghe