here_you_go_read_carefully
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
here_you_go_read_carefully [2016/04/26 18:48] – dongbinkim | here_you_go_read_carefully [2016/04/26 19:09] (current) – dongbinkim | ||
---|---|---|---|
Line 13: | Line 13: | ||
- Select (.STL) type, then Save. | - Select (.STL) type, then Save. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Go to workdesk where you can see ROBO 3D Printer. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Find ' | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - This is the display you will see. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Find ' | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Click ' | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - You are lucky if you get to see CAD model fit on the plate. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - But, Normally you are going to face this issue. The more the model gets fit on the plate, the better quality materials you get. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Find ' | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - You are going to see those menus on the top right. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Use the correct menu to adjust the model until it fits on the plate. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Click ' | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - On ' | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - At ' | ||
+ | |||
+ | - Recommendation : 10~20 support% for normal CAD design. | ||
here_you_go_read_carefully.txt · Last modified: 2016/04/26 19:09 by dongbinkim