Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |
| haaga_acr_alvaro_work_log [2016/06/17 16:55] – pareshbrahmbhatt | haaga_acr_alvaro_work_log [2016/06/17 16:56] (current) – pareshbrahmbhatt |
|---|
| |
| // | // |
| I was finally able to retrieve info from the Jetson. I first tested with a get partition table command, and it worked, but I could't run another command after. It would do the same thing it always does, start, and sit there and do nothing for eternity. I am not sure if the Jetson is setup this way, that after one command it won't take another, and it just becomes a potato because for the most part the only reason you use the USB-B connection to the Jetson is to flash a new OS and then it auto restarts. If you turn it off and reset it Force Recovery Mode you can run a command again, but not two consecutively. I will investigate the manner further. For now, I have used my one command to clone the current APP partition of Jeongmin's setup so I have a backup. | I was finally able to retrieve info from the Jetson. I first tested with a "get partition table" command, and it worked, but I could't run another command after. It would do the same thing it always does, start, and sit there and do nothing for eternity. I am not sure if the Jetson is setup this way, that after one command it won't take another, and it just becomes a potato because for the most part the only reason you use the USB-B connection to the Jetson is to flash a new OS and then it auto restarts. If you turn it off and reset it Force Recovery Mode you can run a command again, but not two consecutively. I will investigate the manner further. For now, I have used my one command to clone the current APP partition of Jeongmin's setup so I have a backup. |
