diary
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
diary [2017/02/16 08:46] – jeanvaz | diary [2017/04/20 14:24] (current) – jeanvaz | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== CnC learning sections - Diary====== | ====== CnC learning sections - Diary====== | ||
- | **Author:** Jean Chagas Vaz **Email:** chagasva@unlv.nevada.edu | + | ====== DASL 104: Humanoid Robotics ====== |
- | \\ | + | |
- | **Date:** Last modified on 02/16/17 | + | **Author: |
+ | **Date:** Last modified on 04/20/2017 \\ | ||
\\ | \\ | ||
**Keywords: | **Keywords: | ||
Line 190: | Line 191: | ||
Problems: \\ | Problems: \\ | ||
- ALWAYS MAKE SURE TO TRY OUT THE CYCLE AT A HIGHER Z POSITION FOR A SAFETY TRYOUT.\\ | - ALWAYS MAKE SURE TO TRY OUT THE CYCLE AT A HIGHER Z POSITION FOR A SAFETY TRYOUT.\\ | ||
+ | </fc> | ||
+ | |||
+ | \\ | ||
+ | <fc blue> | ||
+ | * 02/16/2017 08:55AM to 11: | ||
+ | </fc> | ||
+ | |||
+ | - Make a circular pocket with 0.01 of precision\\ | ||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Prepare the Aluminium block to finally use fusion 360 G code to machine a pre-design part. | ||
+ | |||
+ | {{youtube> | ||
+ | |||
+ | {{youtube> | ||
+ | |||
+ | <fc green> | ||
+ | Things to do by next section: \\ | ||
+ | - Go to local market to but extra drills\\ | ||
+ | </fc> | ||
+ | |||
+ | <fc red> | ||
+ | Problems: \\ | ||
+ | - USE THE SMOOTH MALLET TO remove the tool from the spindle\\ | ||
</fc> | </fc> | ||
diary.txt · Last modified: 2017/04/20 14:24 by jeanvaz