connecting_the_threaded_rod
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
connecting_the_threaded_rod [2016/04/11 00:33] – created suyonglee | connecting_the_threaded_rod [2016/04/11 01:18] (current) – suyonglee | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | Connecting the Threaded Rod | + | **Connecting the Threaded Rod** |
+ | |||
+ | 1. Prepare the M10x1m Threaded Rod x4 and M10 Prong Tee Nut x4 | ||
+ | |||
+ | {{: | ||
+ | |||
+ | 2. Cut the Rod for 22 inch x2 using Hand Saw | ||
+ | |||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | 3. Make a suitable size square (ex.5x5cm diameter) to connect the Tee nut, and make a 1cm diameter whole and then connect the Tee nut to the square using Hammer. | ||
+ | |||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | 4. Attach the Square to the stand of Y axis and the Moving square of Y axis. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | 5. Connect the Threaded Rod, the original size is to X-axis and the cutting size is Y-axis. | ||
+ | 5-1 before connecting, making a whole in the Y-axis moving whole and then connect the Hook for attaching the Wire. |
connecting_the_threaded_rod.txt · Last modified: 2016/04/11 01:18 by suyonglee