connect_the_motors_with_servo_controller
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
| — | connect_the_motors_with_servo_controller [2016/05/25 01:48] (current) – created dongbinkim | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | **Connect the motors with servo controller.** | ||
| + | 1. Install the software " | ||
| + | |||
| + | -Visit the link below, install the software and watch Youtube demonstration. It will help a lot! | ||
| + | |||
| + | Link : https:// | ||
| + | |||
| + | |||
| + | 2. Servo motor adjustment with Pololu Maestro Servo Center. | ||
| + | |||
| + | {{: | ||
| + | |||
| + | - For the adjustment, make sure you do this **without** servo-arm attached. | ||
| + | - With the software, see the photo on the left, you should turn shaft on opposite direction of movement to maximum because it has to move from vertical to horizontal to manipulate easier. Then, attach vertically the arm on the shaft. | ||
connect_the_motors_with_servo_controller.txt · Last modified: 2016/05/25 01:48 by dongbinkim