User Tools

Site Tools


mount_the_servo_motors

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

mount_the_servo_motors [2016/03/20 17:13] (current)
dongbinkim created
Line 1: Line 1:
 +**-Mount the servo motors**
  
 +{{:​img_5754.jpg?​200|}}
 +
 +1. Clean the servo motors with alcohol or any solvent if they are greasy, then apply double-sided tape to them.
 +
 +{{:​img_5755.jpg?​200|}}
 +
 +2. Attach the servos to the deck that you just cut, with their wires toward the front and their shafts toward the outside edges. if the wires are too short to reach to the center, you probably need to move the servos closer to the center.
 +
 +{{:​img_5756.jpg?​200|}}
 +
 +3. To reinforce both the servos, Tie them with zip ties! Place the holes for the zip ties very close to the servo so the servo can't move.
mount_the_servo_motors.txt ยท Last modified: 2016/03/20 17:13 by dongbinkim