Differences

This shows you the differences between two versions of the page.

--- moldmaking:how_the_pros_replicate_objects [2016/03/28 17:03] – created yeeunkim
+++ moldmaking:how_the_pros_replicate_objects [2016/04/11 11:29] (current) – yeeunkim
@@ Line 1: / Line 1: @@
-====== M Tutorials ======
+====== <Moldmaking : How the pros replicate objects> ======
-==== Author: Jadin Tredup ====
 ----
 **Introduction:**\\
-The big picture of these exercises is to familiarize students with the basics of constructing and designing pneumatic circuits using Lego components. These tutorials will show you first how to construct a Lego pneumatic cylinders with both one and two switches, a motorized Lego air compressor, and a simple circuit using the components from the previous tutorials. The photo below depicts the circuit students will build in the final tutorial.
+This tutorial explains how to make a two-part mold, which is the beginner-friendly type and great for small toy.
-{{ ::yeeun_picture_manhattan.jpg?200 |}}
 ----
-**Parts List and Sources:**\\
+**[[Materials]]**\\
-A lot of the parts needed for these tutorials have been discontinued by Lego. As a result, they must be bought from mostly secondhand stores. At the time of writing these tutorials, these were the vendors I found to have the most stock of each piece available.\\
+**Instructions**\\
+  *[[1. Design the mold]]
+  *[[2. Pour the Silicone]]
+  *[[3. Cut the Mold]]
+  *[[4. Cast]]
+  *[[5. Paint]]
-<html><iframe width="560" height="315" src="https://www.youtube.com/embed/6__TKYYJAkI" frameborder="0" allowfullscreen></iframe></html>