User Tools

Site Tools


mm-uav_slave_arm-servo_arm-top_plate_assembly

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

mm-uav_slave_arm-servo_arm-top_plate_assembly [2016/05/13 20:30] – created dongbinkimmm-uav_slave_arm-servo_arm-top_plate_assembly [2016/05/13 23:04] (current) dongbinkim
Line 47: Line 47:
 - Mark numbers on top plate and servo plate to connect the both correctly. - Mark numbers on top plate and servo plate to connect the both correctly.
  
 +
 +{{:mmuav_42_.jpg?300|}}
 +
 +- Put Twine through the connectors on Top plate. And pull it until you see no space between connectors and you feel force from the spring, then use a pen to mark it.
 +
 +
 +{{:mmuav_43_.jpg?300|}}
 +
 +- Pull the twine to 2cm and Use M2.5*5mm screw and Flat washer to anchor the hole. We are going to use force from spring to stand the UAV, you should pull the twine 2cm from each slave arms to the balance.
 +
 +
 +{{:mmuav_44_.jpg?300|}}
 +
 +- Connection complete.
 +
 +
 +{{:mmuav_45_.jpg?300|}}{{:mmuav_46_.jpg?300|}}
 +
 +- Connect the servo arm on the motor, you should make sure each number you have drawn on both plates are matched.
 +
 +
 +-NICE JOB! 
  
  
mm-uav_slave_arm-servo_arm-top_plate_assembly.txt · Last modified: 2016/05/13 23:04 by dongbinkim