Differences

This shows you the differences between two versions of the page.

--- mm-uav_plate-servo_assembly [2016/05/04 14:10] – created dongbinkim
+++ mm-uav_plate-servo_assembly [2016/05/04 14:22] (current) – dongbinkim
@@ Line 4: / Line 4: @@
 {{:mmuav_8_.jpg?300|}}
 {{:mmuav_9_.jpg?300|}}
+- Inside of the servo motor box, you can see 2 brackets. Use scissors to cut one of the edge side, then connect them to the servo motor.
+{{:mmuav_10_.jpg?300|}}
+- Put drill on each hole on the plate, drill the bigger for the M2*25mm screws.
+{{:mmuav_11_.jpg?300|}}
+{{:mmuav_13_.jpg?300|}}
+- Place servomotors on the Bottom plate, put M2*25mm screws from the bottom, then cover them with Nylon unthreaded spacers.
+{{:mmuav_12_.jpg?300|}}
+- Put the top plate, then fix it with M3 Nyloc nuts.