User Tools

Site Tools


mm-uav_arm

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
mm-uav_arm [2016/05/04 13:44]
dongbinkim
mm-uav_arm [2016/05/04 14:23]
dongbinkim
Line 10: Line 10:
 - Put connector A in the Tubes. - Put connector A in the Tubes.
  
 +{{:​mmuav_20_.jpg?​300|}}
  
 +- Drill two holes on the bracket in a size of M2*6mm screw and M2 nut.
 +
 +{{:​mmuav_21_.jpg?​300|}} {{:​mmuav_22_.jpg?​300|}} {{:​mmuav_23_.jpg?​300|}}
 +
 +- Anchor the screw on the servo arm plates following the picture. Up to the quality of 3D printer, you might need to drill the hole to bigger to create space for screws. Then, assembly the rests with Carbon Fiber arm
 +
 +{{:​mmuav_25_.jpg?​300|}}
 +
 +- You should twist the arm until the plate and the connector arranged vertically.
 +
 +{{:​mmuav_26_.jpg?​300|}}
 +
 +- Zip tie the arms.
 +
 +{{:​mmuav_19_.jpg?​300|}}
 +
 +- Complete
mm-uav_arm.txt ยท Last modified: 2016/05/04 14:23 by dongbinkim