This is an old revision of the document!
Making the X axis moving part
-Drawing part
1. Prepare 24” (600nm) Drawer Slide x4
2. Cut the quadrangle for 32x8inch size x2, 8x6inch size x2, 19x6inch sixe x2(reuse the wrong size Y-axis board), and 3x3inch x4
-3.,4.
3. Make a whole in 19x6inch board, this whole sixe is same and parallel to the X axis motor seats. so when you make a whole, 1.4 inch diameter, you have to be consider the bottom stuff's height such as 32×8 inch and 8x6inch board, and drawer slide. In my case the bottom stuff's height is 1 inch, so I make a center of the whole in 1.3inch height, and 3 inch by widthwise.
4. stand the Y axis moving part and the board that has a whole on the 8x6inch size board using screws
-5
-5-1
5. if you finish the standing, you have to fix the bottom side of 8x6inch board to the Drawer slide using screws but, If you use just 2 screws to fix it, it will not be fixed, 5-1 so, you should use 4 screws to fix it.
6. if you finish the fixing, make it attach the 32x8inch board, when you attach it, left the 3inch space for X axis motor seats.
-7
7. attach the 3×3 size board to the left 3inch space, and attach the X axis motor seats.