making_the_x_axis_moving_part
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
making_the_x_axis_moving_part [2016/04/01 20:34] – suyonglee | making_the_x_axis_moving_part [2016/04/01 20:54] – suyonglee | ||
---|---|---|---|
Line 6: | Line 6: | ||
1. Prepare 24” (600nm) Drawer Slide x4 | 1. Prepare 24” (600nm) Drawer Slide x4 | ||
- | 2. Cut the quadrangle for 32x8inch size x2, 8x6inch size x2, and 19x6inch sixe x2(reuse the wrong size Y-axis board) | + | 2. Cut the quadrangle for 32x8inch size x2, 8x6inch size x2, 19x6inch sixe x2(reuse the wrong size Y-axis board), and 3x3inch x4 |
- | {{: | + | {{: |
+ | -3.,4. | ||
- | 3. Make a whole in 19x6inch board, this whole sixe is same to the X axis motor seats. | + | 3. Make a whole in 19x6inch board, this whole sixe is same and parallel |
+ | |||
+ | 4. stand the Y axis moving part and the board that has a whole on the 8x6inch size board using screws | ||
+ | |||
+ | {{: | ||
+ | -5 | ||
+ | {{: | ||
+ | -5-1 | ||
+ | |||
+ | 5. if you finish the standing, you have to fix the bottom side of 8x6inch board to the Drawer slide using screws but, If you use just 2 screws to fix it, it will not be fixed, | ||
+ | 5-1 so, you should use 4 screws to fix it. | ||
+ | |||
+ | 6. if you finish the fixing, make it attach the 32x8inch board, when you attach it, left the 3inch space for X axis motor seats. | ||
(upload soon) | (upload soon) |
making_the_x_axis_moving_part.txt · Last modified: 2016/04/01 21:01 by suyonglee