User Tools

Site Tools


making_the_x_axis_motor_seats

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
making_the_x_axis_motor_seats [2016/04/01 16:39]
suyonglee
making_the_x_axis_motor_seats [2016/04/01 16:45] (current)
suyonglee
Line 11: Line 11:
 -back side picture -back side picture
  
-1. saw the quadrangle for 6x6inch size x2 and 6x3inch x2+1. Cut the quadrangle for 6x6inch size x2 and 6x3inch x2
  
-2. make a whole, 1.4 inch diameter, in the 6x6inch wood to suit for stepper motor!+2. Make a whole, 1.4 inch diameter, in the 6x6inch wood to suit for stepper motor!
 - the center of the whole'​s position: center of the width (3 inch by widthwise), 2.3inch of the height - the center of the whole'​s position: center of the width (3 inch by widthwise), 2.3inch of the height
 - It must be considered with motor'​s center - It must be considered with motor'​s center
 +
 +3. assemble the 6x6inch wood and 4x4inch wood to be perpendicular!
 +- When I screw the 2 structure, It was hard to make it stand perpendicularly,​ so I screwed the small size square on the both side the structure.
  
making_the_x_axis_motor_seats.txt ยท Last modified: 2016/04/01 16:45 by suyonglee