laser_cutters_for_potential_purchase
Differences
This shows you the differences between two versions of the page.
Last revisionBoth sides next revision | |||
laser_cutters_for_potential_purchase [2016/01/23 08:10] – created rebeccaseddon | laser_cutters_for_potential_purchase [2016/01/31 20:19] – rebeccaseddon | ||
---|---|---|---|
Line 2: | Line 2: | ||
Objective: Identify 3 laser cutters (economy, mid-range, high-end) for potential purchase. | Objective: Identify 3 laser cutters (economy, mid-range, high-end) for potential purchase. | ||
- | |||
====Economy==== | ====Economy==== | ||
+ | [[http:// | ||
+ | |||
+ | |||
+ | ===General Specifications=== | ||
+ | |||
+ | | ||
+ | |||
+ | | ||
+ | |||
+ | *Air Assist: Attach an air compressor to our included Air Assist to remove excess heat and combustible gases from the cutting surface by directing a constant stream of compressed air across the cutting surface. | ||
+ | |||
+ | | ||
+ | |||
+ | *Red Dot Pointer: Since the laser beam is invisible, a Red Dot Pointer on the Fusion Laser allows you to have a visual reference for locating where the laser will fire. X-Axis Bearings: Ground and polished stainless steel long-lasting bearing system. | ||
+ | |||
+ | ==Pros== | ||
+ | |||
+ | | ||
+ | | ||
+ | |||
+ | |||
+ | ==Cons== | ||
+ | |||
+ | *The maximum material thickness is 5mm. | ||
+ | *The air compressor is a separate purchase. | ||
+ | | ||
====Mid-Range==== | ====Mid-Range==== | ||
+ | [[https:// | ||
+ | ===General Specifications=== | ||
+ | |||
+ | ==Pros== | ||
+ | |||
+ | ==Cons== | ||
====High-End==== | ====High-End==== | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | ===General Specifications=== | ||
+ | |||
+ | ==Pros== | ||
+ | |||
+ | ==Cons== |
laser_cutters_for_potential_purchase.txt · Last modified: 2016/02/01 12:23 by rebeccaseddon