how_to_make_a_chair_cover_with_name
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
how_to_make_a_chair_cover_with_name [2019/01/07 17:52] – myeonggeonkim | how_to_make_a_chair_cover_with_name [2019/01/11 14:41] (current) – myeonggeonkim | ||
---|---|---|---|
Line 89: | Line 89: | ||
\\ | \\ | ||
{{: | {{: | ||
+ | \\ | ||
\\ | \\ | ||
2. Print your design. | 2. Print your design. | ||
Line 101: | Line 102: | ||
\\ | \\ | ||
{{: | {{: | ||
+ | \\ | ||
\\ | \\ | ||
3. Cut the fabric that you are going to use for the chair cover. The fabric size should be bigger than the planer figure. | 3. Cut the fabric that you are going to use for the chair cover. The fabric size should be bigger than the planer figure. | ||
\\ | \\ | ||
- | Put the fabric on the laser cutter | + | -Put the fabric on the laser cutter |
\\ | \\ | ||
- | Check the [[http:// | + | - *Check the [[http:// |
\\ | \\ | ||
- | Make sure that laser cutter is on and connected with Retina engrave. | + | - Make sure that laser cutter is on and connected with Retina engrave. |
\\ | \\ | ||
- | Check your work place on laser cutter by pressing ‘J or P’ on Retina engrave. | + | - Check your work place on laser cutter by pressing ‘J or P’ on Retina engrave. |
\\ | \\ | ||
- | After checking the work place, adjust location of fabric and put magnets on the safe location on the fabric. This step will help the fabric not to be moved by air compressor. | + | - After checking the work place, adjust location of fabric and put magnets on the safe location on the fabric. This step will help the fabric not to be moved by air compressor. |
\\ | \\ | ||
{{: | {{: | ||
+ | \\ | ||
\\ | \\ | ||
4. Run the laser cutter | 4. Run the laser cutter |
how_to_make_a_chair_cover_with_name.txt · Last modified: 2019/01/11 14:41 by myeonggeonkim