DASL Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
<fs x-large>DASL Robo3D printer manual via PC</fs>

**How to do 3D-Printing**
\\
\\
{{:3d_printer.jpg?400|}}

- Open Solidpart file, or any CAD file that you can convert into (.STL) file.

{{:3d_printer2.jpg?400|}}

- Select "Save as" to save the part file as (.STL) file.

{{:3d_printer3.jpg?400|}}

- Select (.STL) type, then Save.

{{:3dprinter1_1_.jpg?400|}}

- Go to workdesk where you can see ROBO 3D Printer.

{{:3dprinter1_3_.jpg?400|}}

- Find 'Matter Control' file and run.

{{:3dprinter1_4_.jpg?400|}}

- This is the display you will see.

{{:3dprinter1_5_.jpg?400|}}

- Find 'ADD' button at the bottom left. then add the STL file that you just converted from Solidworks

{{:3dprinter1_6_.jpg?400|}}

- Click 'View' button.

{{:3dprinter1_7_.jpg?400|}}

- You are lucky if you get to see CAD model fit on the plate.

{{:3dprinter1_8_.jpg?400|}}

- But, Normally you are going to face this issue. The more the model gets fit on the plate, the better quality materials you get.

{{:3dprinter1_9_.jpg?400|}}

- Find 'Edit' button from the bottom left, then click it.

{{:3dprinter1_10_.jpg?400|}}

- You are going to see those menus on the top right.

{{:3dprinter1_11_.jpg?400|}}

- Use the correct menu to adjust the model until it fits on the plate.

{{:3dprinter1_12_.jpg?400|}}

- Click 'Save'

{{:3dprinter1_13_.jpg?400|}}

- On 'Matter Control' display, find 'Settings & Controls' button. then Click it.

{{:3dprinter1_14_.jpg?400|}}

- At 'Settings', go 'General' then find 'Support Material'. Support Material is to help 3D Printer create the material precisely by surrounding the original model.

- Recommendation : 10~20 support% for normal CAD design.