cnc_hello_world_tutorial_1
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
cnc_hello_world_tutorial_1 [2017/01/30 09:07] – jeanvaz | cnc_hello_world_tutorial_1 [2017/01/30 15:15] (current) – jeanvaz | ||
---|---|---|---|
Line 74: | Line 74: | ||
\\ | \\ | ||
**Step 5** | **Step 5** | ||
- | \\ Once the file is properly saved and ready to run make sure to check the position of the letter in perspective with the 2x4 wood. The G code is shown at the top left corner. | + | \\ Once the file is properly saved and ready to run make sure to check the position |
\\ | \\ | ||
{{: | {{: | ||
\\ | \\ | ||
- | Figure 5: ..... | + | Figure 5: Home screen. |
- | Next, ...... | ||
- | \\ | ||
\\ | \\ | ||
**Step 6** | **Step 6** | ||
+ | \\ Finally press the CYCLE START in order to initiate the process. | ||
\\ | \\ | ||
+ | {{: | ||
- | Now ...... | ||
- | \\ | ||
\\ | \\ | ||
**Step 7** | **Step 7** | ||
+ | \\ Once the process is done, remove the wood block from the table and check the final result. | ||
\\ | \\ | ||
+ | {{: | ||
- | When .... | ||
\\ | \\ | ||
- | \\ | ||
- | **Step 8** | ||
- | \\ | ||
- | \\ | ||
- | {{:? | ||
- | \\ | ||
- | Figure 8: ...... | ||
- | Start by setting ..... | + | ==== Videos ==== |
- | + | ||
- | \\ | + | |
- | \\ | + | |
- | **Step 9** | + | |
\\ | \\ | ||
+ | {{youtube> | ||
- | Next, | + | {{youtube> |
- | + | ||
- | + | ||
- | \\ | + | |
- | {{youtube> | + | |
// | // | ||
// | // | ||
+ | |||
==== Commentaries ==== | ==== Commentaries ==== | ||
- | This tutorial' | + | This tutorial' |
\\ | \\ | ||
\\ | \\ | ||
- | dfhkjhsdfkjksdfkj | ||
\\ | \\ | ||
\\ | \\ |
cnc_hello_world_tutorial_1.1485796076.txt.gz · Last modified: 2017/01/30 09:07 by jeanvaz