Differences

This shows you the differences between two versions of the page.

--- cnc_hello_world_tutorial_1 [2017/01/29 16:24] – jeanvaz
+++ cnc_hello_world_tutorial_1 [2017/01/30 15:15] (current) – jeanvaz
@@ Line 72: / Line 72: @@
 Finally save the project by clicking "Post to File"
-\\
 \\
 **Step 5**
+\\ Once the file is properly saved and ready to run make sure to check the position (using the jog shuttle) of the letter in perspective with the 2x4 wood (If the letters seems to small or big, adjust the coordinates accordingly). The G code is shown at the top left corner.
 \\
+{{:dsc_5554.jpg?nolink&600}}
 \\
-{{:?nolink|}}
+Figure 5: Home screen.
-\\
-Figure 5: .....
-Next, ......
-\\
 \\
 **Step 6**
+\\ Finally press the CYCLE START in order to initiate the process.
 \\
+{{:dsc_5558.jpg?nolink&600}}
-Now ......
-\\
 \\
 **Step 7**
+\\ Once the process is done, remove the wood block from the table and check the final result.
 \\
+{{:dsc_5552.jpg?nolink&400}} {{:dsc_5563.jpg?nolink&400}}
-When ....
 \\
-\\
-**Step 8**
-\\
-\\
-{{:?nolink|}}
-\\
-Figure 8: ......
-Start by setting .....
+==== Videos ====
 \\
-\\
+{{youtube>qRyifYpdCTc?medium}}
-**Step 9**
-\\
-Next,
+{{youtube>24sd0q9MIOU?medium}}
-\\
-{{youtube>nobExDW7gEk?medium}}
 //
 //
 ==== Commentaries ====
-This tutorial's objective was to .....
+This tutorial's objective was to introduce basic commands and applications for the Thormac 1100 Machine.
 \\
 \\
-dfhkjhsdfkjksdfkj
 \\
 \\