cnc_hello_world_tutorial_1
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
cnc_hello_world_tutorial_1 [2017/01/30 09:14] – jeanvaz | cnc_hello_world_tutorial_1 [2017/01/30 09:18] – jeanvaz | ||
---|---|---|---|
Line 74: | Line 74: | ||
\\ | \\ | ||
**Step 5** | **Step 5** | ||
- | \\ Once the file is properly saved and ready to run make sure to check the position (using the jog shuttle) of the letter in perspective with the 2x4 wood. The G code is shown at the top left corner. | + | \\ Once the file is properly saved and ready to run make sure to check the position (using the jog shuttle) of the letter in perspective with the 2x4 wood (If the letters seems to small or big, adjust the coordinates accordingly). The G code is shown at the top left corner. |
\\ | \\ | ||
{{: | {{: | ||
Line 88: | Line 88: | ||
\\ | \\ | ||
**Step 7** | **Step 7** | ||
+ | \\ Once the process is done, remove the wood block from the table and check the final result. | ||
\\ | \\ | ||
+ | {{: | ||
- | When .... | ||
- | \\ | ||
\\ | \\ | ||
**Step 8** | **Step 8** |
cnc_hello_world_tutorial_1.txt · Last modified: 2017/01/30 15:15 by jeanvaz