Differences

This shows you the differences between two versions of the page.

--- basic_cutting_in_3-different_woods [2016/06/20 21:39] – suyonglee
+++ basic_cutting_in_3-different_woods [2016/06/20 21:39] – suyonglee
@@ Line 26: / Line 26: @@
 **Step 3**
-watching the etching and repeat in other different sizes
+watch the etching and repeat in other different sizes
@@ Line 32: / Line 32: @@
+===== result 01 =====
+Start etching with Using Retina Energy.
+**thin:**
+\\ {{::20160606_173640.jpg?300|}} \\
+**medium:**
+\\ {{::20160606_173630.jpg?300|}} \\
+**thickest:**
+\\ {{::20160606_173650.jpg?300|}} \\
+ I tried to etch the DSAL. When I tried to first time, Only I could etch thickest wood. so I made laser's strength double, but It was not working. but When I controlled Z axis, I could close the distance between wood and laser, so It was working.
+ so. Wood's thickness is not problem to etch because I can control the distance.