assembly_airplane_frames
This is an old revision of the document!
Assembly Airplane frames
*If you arranged the wire well enough, combine both body frames then grab it tightly. Actually the manual tells you should bond the frames, but you don't know what would happen in the future flight. so I want to recommend to tape the frame very tight. Afterwards, put one long leftover plastic tube into downside of the body, then tape it. At last, bond the Tail/Rudder wing part on the body.
* Bond the carbon fiber tube on one of the wings, then cover it.
* Bond the cover from the wing on the other wing.
* Slide the wing with the tube into the body, then slide the other wing until it attach to another.
* Bond the cover plate at a slot on the body.
*
assembly_airplane_frames.1461925951.txt.gz · Last modified: 2016/04/29 03:32 by dongbinkim